Operation Manual

23
4
5
6
1
1. Power on and place the disc (with label side facing users) to the door and the unit
will draw in the disc and switch signal source to DVD mode automatically.
2. Press [ ] button to begin playing disc.
3. Press [ ] button to stop playing.
5. When finishing playing, switch signal source to other working state or press [ ]
button to make the unit enter standby state. Please pull out the power plug from
power socket when not using the unit for a long time.
The unit begins to read disc information.
CDVCDSVCD
DVD
4. Press [ ] button to take out disc.
EJECT
STANDBY
PLAY
STOP
When the unit is playing a disc, press [ ] button the first time and the unit enters pre-stop state,
press [ ] button again and the unit enters stop state.
At the pre-stop state, if you press [ ] button, the unit will continue to play from the stopped point.
At the stop state, if you press [ ] button, the unit will play from the beginning point of the disc.
Press [ ] button when playing MPEG4 discs and the unit enters stop state directly.
DVD OPERATION
27
PLAYBACK
MPEG4
2. Press [VOL+/VOL-] buttons on the remote control of this unit.
Press [VOL+] button to increase volume; press [VOL-] button to decrease volume; the
maximum volume is 100.
CDVCDSVCDDVD
1. Press [VOL+/VOL-] buttons to adjust volume.
MPEG4
VOLUME CONTROL
VOL