Manual

Room Alert 3E
16 AVTECH Software, Inc.
Authentification (Optional)
9. If your mail server requires SMTP authentication, check Enable Authentification.
10. In “Username” and “Password,” enter a valid username and password for your mail
server that will facilitate authentification.
Email Recipients (Separated By Comma)
11. In “Email Addresses,” enter the email and email-to-SMS addresses that you’d like to
send alerts to. Separate each address with a comma.
• Email address: [e-mail]
• Email-to-SMS address: [e-mail]
• Addresses separated by commas: [e-mail], [e-mail],
etc.
12. Click Send Test Email. This button will automatically save any changes made to the
“SMTP Email” tab before sending a test email message.
13. Click Accept Changes at the bottom of your screen.
14. Click Save Settings in the navigation bar to the left of your screen.
TIP
If your test email is not received successfully, check your mail
server’s SMTP relay settings, which must allow anonymous
SMTP relay messages. If you entered a domain name for the
Mail Server Address, you may need to rename it to the IP
address or assign a static IP setting and have a DNS server IP
address set.
TIP
Your password cannot be more than 11 alphanumeric characters.