Manual

Room Alert 3E
AVTECH Software, Inc. 9
Current Sensor Status Bar
Below the “Status” tab is the “Current Sensor Status Bar,” where you may view basic
information about your Room Alert 3E and make temporary adjustments to the sensor display.
• You may find your Room Alert 3E’s name, current date & time, and MAC address here.
• To determine if your Room Alert 3E’s firmware is current, you may click Room
Alert 3E vX.X.X at the right.
• To temporarily modify the refresh interval of the “Status” screen while viewing,
which is 60 seconds (i.e., every 1 minute) by default, you may enter a value in
seconds in the “Update Every” field. Click outside the field to temporarily commit the
change.
• To temporarily toggle the temperature scale between Fahrenheit (F) and Celsius (C),
click Fahrenheit or Celcius.
TIP
Your Room Alert 3E must be connected to the internet to check
firmware versions.
Refer to the Advanced section in this manual for instructions on
setting the default status page refresh rate and temperature
scale for Room Alert 3E.
NOTE