User`s guide
10 AVTECH Inc.
Conguration And Setup Screens TemPageR 3E
Initial Email Setup
First, check the ‘Email Enabled’ checkbox and enter the domain name or IP address of the mail
server being used in the ‘Mail Server’ eld on the ‘SMTP Email’ tab. Next, enter an email address in
the ‘Return Address (From)’ eld for an account that resides on the mail server being used. If SMTP
authentication is required, check the ‘Enable Authentication’ checkbox and enter a valid username
and password for the mail server. Finally, enter the email addresses to be alerted when alarms occur
in the ‘Email Addresses’ eld. If more than one email address is entered, use a comma (,) as the
separator. Once all SMTP Email settings are congured, click the ‘Accept Changes’ button then
‘Save Settings’.
NOTE: If a domain name is entered in the ‘Mail Server Address’ eld, the TemPageR 3E unit must be assigned static IP
settings and have a DNS server IP address set.
Test Email
A test email can be sent to the congured recipients using the ‘Send Test Email’ button after valid
email settings have been congured and saved. If the test email is not received, check with the
mail server administrator in regards to the current SMTP relay settings. The ‘Trace’ feature on the
‘Advanced’ tab of the settings is also useful for troubleshooting email and other issues. For more
information, please see the ‘Advanced Settings’ section of this manual.
Email-To-SMS
Email alert notications can be sent via Short Message Service (SMS) to computers, mobile phones,
BlackBerrys, pagers and PDAs using SMS text messaging in addition to regular email. This functionality
is widely supported by current mobile device service providers and is accomplished by sending email to an