Quick Start Guide

NVR4
V. 01 – 14/04/2014 4 ©Velleman nv
• local and remote control completely independent
• HDMI video output resolution up to 1080p
• automatic integrated Dynamic Domain Name Service (DDNS): free service
• USB mouse: incl.
• IR remote control: incl.
Optional hardware
• hard disk: HD500GB/S, HD1TB/S, HD2TB/S
• monitor: MONSCA9
• HDMI cable: PAC400Tx series and PAC400Gx series
• compatible IP cameras: CAMIP16, CAMIP17, CAMIP18, CAMIP19
• router: EM4544, EM4543, EM4571, PCRT1
5. Overview
Front panel
alarm LED indicator: an alarm event occurs
wan LED indicator: the NVR is connected to internet
lan LED indicator: the NVR is connected to the LAN
SATA
LED indicator: SATA hard disk is active
HDD1 to HDD5
LED indicator: up to 5 hard disks are installed in the NVR and connected well
(3 HDD with quick-lock installation)
USB port
Insert a compatible USB flash drive for video backup.
Note: For the list of compatible USB flash drives, refer to the full manual on the
CD-ROM.
mouse port Insert a mouse (included).
Back panel
1
AUDIO OUT
Connect to an amplifier audio line-in.
2
HDMI video output
port
Connect to a monitor that supports high-definition video output (HDMI port).
Note: Use an appropriate adapter (not incl.) to connect a monitor with VGA or
composite connectors.
3
External I/O
RS 485 port
4 eSATA
This port is used to connect a storage device supporting eSATA interface; for
instance, an external disk array.
5 WAN Connect to internet via an 8P8C (RJ45) network cable
6
LAN
Connect to local IP cameras via an 8P8C (RJ45) network cable.
7 DC 19V IN Connect to the power supply adapter (incl.).
1 2 3 4 5 6 7