Technical data

PAGE 56
Operation via Windows PC Software
Under POTS Line/ISDN Line you select if you want to signal the status
of Line 1, Line 2, Line 3, Line 4, Line 5, Line 6 or all lines (Any). If you
select Any, the signal is set on the TTL Pin as soon as one of the lines
has the predefined status.
– Audio Line: With this function you can signal when a caller is switched
to a certain Audio line. Please select under Audio Line the desired Au-
dio line. Under POTS Line/ISDN Line you select if you want to signal
the status of Line 1, Line 2, Line 3, Line 4, Line 5, Line 6 or all lines
(Any). If you select Any, the signal is set on the TTL Pin as soon as one
of the lines has been set to the predefined Audio line.
– ON AIR: If you select this function, it is signalled when a caller is
switched to ON AIR. Under POTS Line/ISDN Line you select if you
want to signal the ON AIR status of Line 1, Line 2, Line 3, Line 4, Line
5, Line 6 or all lines (Any). If you select Any, the signal is set on the TTL
Pin as soon as one of the lines is switched to ON AIR.
– PRETALK: If you select this function, it is signalled when a caller is
switched to Pretalk. Under POTS Line/ISDN Line you can select if you
want to signal the Pretalk status of Line 1, Line 2, Line 3, Line 4, Line 5,
Line 6 or all lines (Any). If you select Any, the signal is set on the TTL
Pin as soon as one of the lines is switched to Pretalk.
– Ringing/Connected State: Toggeling of voltage when a call is coming
in (e.g. for flashing light). When the connection is established, the TTL
Pin is set.
– Called Number:
– Information Base Entry: Special function for projects.
– Any System Alarm Pending: This function signals any system alarm.
– Application Alarm Pending: If you enable this function, you can select
under Alarm which Application Alarm you want to signal.
– DTMF Digit Received:
– ON AIR by Terminal:
If you select the option Inverted, which is displayed next to the function code,
the inverted signal is transmitted.
Relay
The following description applies for the configuration windows Relay 1, Re-
lay 2, Relay 3 and Relay 4.
ATTENTION Please pay attention to the maximum switch current of 200 mA respectively
the maximum switch voltage of 48V per relay output.
!