Technical data

PAGE 31
Operation via Windows PC Software
Operation via the Windows PC Software
In the following chapters, all functions of the PC Software are described in de-
tail.
5.5 The MAGIC TH6 main window
After starting the MAGIC TH6 Software, the main window is displayed auto-
matically (see Fig. 11).
The connection status between PC and system is displayed in the upper right
corner of the window:
PC ONLINE: Connection is okay.
PC OFFLINE: Connection with PC is faulty
The Following further status messages are possible:
PC ONLINE ALARM:
see System Monitor
WRONG APPLICATION:
You are using the wrong software, e.g. for
MAGIC TH2plus.
BOOT MODE: There is no valid firmware on
the system. Please execute a firmware
download (see CHAPTER 5.7.4, Page 87).
NOTE
If the connection is faulty, please check the following points:
– Power supply cable of the system is plugged in and unit is switched on
(display available)
– LAN or serial 1:1 cable is connected with PC and system
– Correct IP Address and Port are selected (if LAN interface is used)
– COM port and correct baud rate are selected in the software (if RS232 in-
terface is used)