Technical data

PAGE 90
Windows PC Software
– FLASH EPROM: The communication with the permanent memory is
faulty. Configurations cannot be saved or read anymore.
– Ethernet MAC: The initialization of the ethernet module has failed.
– Overheated: The system sets this alarm if the system temperature is
higher than 57°C. Disconnect the unit from electricity or cool down the
ambient temperature.
– MAIN EEPROM: The communication with the permanent memory is
faulty. Configurations cannot be saved or read anymore.
– Display Contrast DAC: The communication with the display contrast
DAC is faulty.
– VCXO: The communication with the voltage-controlled oscillator is
faulty.
•Under Application alarms you will find all potential application alarms.
A red LED signalises a currently existing alarm. The error counter shows
how often the alarm occurred after the unit has been connected to power.
– AES3 Framing Input 1: If the digital Audio input is selected in the con-
figuration dialogue, but no digital Audio signal is available at the AU-
DIO 1/AES IN interface, the AES3 Framing Input 1 alarm will be set.
– Ethernet Mode Supported: The Ethernet Mode alarm will be set if
your ethernet mode is not supported by the system. This is the case for
a 10 Mbit/s half duplex connection. Our recommendation is 100
Mbit/s full duplex.
– AES3 External Clock: Currently not applicable.
• The actual system temperature is displayed in °C under System Temper-
ature.
• Ethernet status shows information about your ethernet connection.
•Under Abs. data rates the absolute data rates of your ethernet connec-
tions are displayed. TX stands for transmit direction and RX for receive di-
rection.
•Under Ethernet physical flags the following ethernet flags are displayed:
– Extended
– Auto
– Negot.
– Jabber
– Remote Fault
• All details concerning the LAN and IP settings are displayed under IP de-
tails.
– IP Address
– Sub Net Mask
– Default Gateway
– DNS Server
– DHCP state
TIP
A system alarm can also be configured as relay output (see Page 57).