Technical data

PAGE 90
Option: Remote Control & ISDN Monitor
FIG. 53 MSN CONFIGURATION FOR REMOTE CONTROL
•Under Number you enter the telephone number of the remote system,
which you want to operate by remote control, or you select an entry from
the phone book by pressing the Phone Book button.
• If the remote station is protected by a remote password, you must enter
this password under Password to get access the remote system (see
CHAPTER 5.6.1.2.5).
• The connection to the remote station is established by pressing the button
Connect and it is dropped via the button Disconnect. The connection sta-
tus is displayed in the status window underneath. If the connection has
been established successfully, the message Remote control online is dis-
played, like in the following figure.
FIG. 54 REMOTE CONTROL ONLINE
Now, the MAGIC TH2 System can be operated and configured as usual. One
of the two B channels is busy by the remote control so that there is only one
channel available for the user. The remote station can also disconnect the re-
mote control at any time.
The main window of the MAGIC TH2 Software displays the existing connec-
tion under Remote Management. To stop the remote configuration press the
key.
ATTENTION If the access to the remote station is protected by authorised phone numbers,
you must carry out the remote access exactly via the ISDN line whose number
is entered in the list. The CLIP function must be enabled for that line.
!