Technical data

PAGE 47
Windows PC Software
5.6.1.1.3 HOLD Signal
The configuration of the HOLD signal can be carried out under Hold Signal.
FIG. 17 RECORDED HOLD SIGNAL
General settings
• Under the setting HOLD signal source you can select the HOLD signal
that you want to use.
With the option ON AIR the signal which is transmitted via the AUDIO 1
respectively AUDIO 2 input interface is used as HOLD signal. In this set-
ting no further options can be configured.
If you select Recorded Hold Signal, the caller hears the Audio signal
stored in the system. The signal is identical for both lines (in ISDN operat-
ing mode).
• With the use of the slide control Pause between repetition you can set the
pause between the repetitions of the recorded signal. The pause time
ranges from 0 to 30 Seconds.
HOLD signal recording
• To record a HOLD signal you can select the line on which the signal is re-
corded under Record source. The options are: Audio 1, Audio 2 or Hand-
set/Headset.
• Via the button Start you start the recording. With Stop the recording is
stopped. With Save the recorded signal is saved in the permanent mem-
ory (FLASH-EPROM) of the system.
• The duration of the HOLD signal is displayed under HOLD signal dura-
tion. The maximum duration of a recorded signal is 6,383 seconds.