Technical data

PAGE 42
Windows PC Software
– ISDN Single Hybrid: The system is operated with ISDN, but only one
channel of the two available B channels is used. If there is a call on the
second channel, the system signalises ’Line busy’. Only the
Audio1/AES IN/OUT interfaces (see Fig. 6 and Fig. 7) are used.
– ISDN: The system is connected to the ISDN and two independent hy-
brids are available.
– POTS: The system is connected to an analogue telephone line. In this
operating mode only one channel is available in general. Only the
Audio1/AES IN/OUT interfaces (see Fig. 6 and Fig. 7) are used.
•Via the function Enable Auto Answer on Audio Line the auto answer can
be activated. Under the option Current Audio Line , PRETALK, HOLD or
ON AIR you can set which Audio line is activated automatically after the
call has been accepted.
• It is possible to activate a ring tone as audible signal for incoming calls via
the function Enable System Ringing Tone.
•If you select Enable Ringing Tone on Handset/Headset incoming calls
can be signalised via the Pre Talk Audio line if a telephone handset or
headset is connected.
•If the POTS 50 Hz Filter is activated, a disturbing 50 Hz humming is fil-
tered out. The spurious signal is injected via the POTS connection in the
system.The reason is in the majority of cases an incorrect cabling of the pri-
vate branch extension.
• Via the slide control POTS Redial Delay it is possible to insert a pause be-
fore redialling - directly after disconnection - in a range of 0 ... 7 seconds.
Prefix number
•Under Length of internal telephone numbers the length of your internal
telephone numbers is set. Subsequently, the prefix number is automati-
cally dialled first if the length of the telephone number exceeds the length
specified in this setting.
If you do not want to use this function or if you operate the system with a
main telephone station, enter 0.
Examples:
Length of internal telephone numbers: 3
Entered telephone number: 130
Dialling: 130
Length of internal telephone numbers: 3
Entered telephone number: 5271130
Dialling: 0 5271130
NOTICE
The following configurations are only necessary if the system is operated
with a private branch exchange.