Technical data

PAGE 98
MAGIC TOUCH Software
7.7.3.14 Audio Lines (Configuration of the Audio interfaces)
The Audio interfaces are configured with the Audio Lines link (configuration
of the Audio interfaces) .
FIG. 66 CONFIGURATION OF THE AUDIO INTERFACES
After pressing the OK button, all settings are accepted.
The Cancel key deletes all settings.
7.7.3.14.1 AES/EBU/ANALOGUE Module
When using digital AES/EBU outputs the clock can be defined with Clock
source of digital output, which operates this interface. The following settings
are possible:
– Recovered Clock (from digital audio input)
This setting can be used if a digital source is connected to the digital input.
The digital output signal is synchronous to the digital input signal.
– Internal Clock
The clock for the output of the digital output signal is generated internally.
In this case the sample rate is always 48-kHz.
– External Clock
In this setting the clock that defines the frequency of the output signal
must be fed in via the BNC. The sample rate must be 48-kHz.
The corresponding word clock can be accessed as an output via the BNC con-
L
The following configuration is only possible if an AES/EBU/ANALOGUE
Module is equipped. If the module is not equipped see CHAPTER 7.7.3.14.2.