Technical data

PAGE 51
MAGIC TOUCH Software
7.5.2 Line functions
The following figure shows the possible line modes:
FIG. 26 LINE FUNCTIONS AND MODE DISPLAY
7.5.2.1 Line functions without existing connection
If there is no connection the following functions are available:
– By pressing the (Pre Talk), the (Hold) or the (On Air) but-
ton, either the manual call dialog or the telephone book opens depending
on the configuration. The configuration of this optional function is done
via General
→ Miscellaneous Settings → Show dial dialog on disconnect
(see CHAPTER 7.7.3.1, page 58).
– With the help of the information button, a line can be predefined
for a call (see Fig. 25, page 50)
7.5.2.2 Line functions with existing connection or incoming call
If there is an existing connection or an incoming call the following functions
are available:
– The (Pre Talk) key switches the caller in pre talk . This key is only
available if a Pre Talk Audio interface was defined in Audio Lines (see
CHAPTER 7.7.3.14, page 98).
– The (Hold) key puts the caller in the hold position . Now the caller
hears the selected signal, defined in Hold Signal Recording/Source
→ Gen-
eral Settings
→ Hold Signal Source (see CHAPTER 7.7.3.10, page 87).
L
Depending on the usage of the MAGIC TOUCH LAN or MAGIC SCREENER
software options, single lines can be highlighted in grey. Then the MAGIC
TOUCH user has no further access anymore to this line. Transfer point is al-
ways the Hold mode. It sets a line free.
No
Connection
Incoming call
(blinking)
Caller in
Pre Talk
Caller in Hold
position
Caller
On Air
Caller being for-
warded
Predefined
call