Technical data

PAGE 103
MAGIC TOUCH Software
– Incoming call on B channel: if there is an incoming call on a certain B chan-
nel the relay will be closed. The B channel can be defined in the second col-
umn. According to the setting S0 Line
→ General → Number of B Channels
visible (see CHAPTER 7.7.3.4.1, page 73) the possible B channels are dis-
played.
– ON AIR & Alt. ON AIR: the relay will be closed as soon as one of the lines
is switched in the On Air or Alternative On Air mode (see CHAPTER
7.7.3.1.2, page 60).
– Audio Line: as soon as one of the lines is switched to the mode defined in
the second column the relay will be closed. In this selection all defined Au-
dio interfaces (see CHAPTER 7.7.3.14, page 98) will be displayed.
The default settings will be defined by pressing Default Settings.
In the Master system the function of the relays will be set as following:
– Relay 1: Incoming call (PC controlled)
– Relay 2: ON AIR & Alt. ON AIR
– Relay 3: Audio Line
→ PRE TALK
When using slave systems all relays will be set to Fixed → always open.
,
If the General → Pre Talk Relay → Pre Talk Signalling combined with Pre
Talk Source option (see CHAPTER 7.7.3.1.4, page 66) is active, the Audio Line
→ PRE TALK setting must be defined at least for one relay.