User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- The Transmitter
- Indicator Troubleshooting Lights - Transmitter
- Functions & Setup of the Transmitter
- Settings Button - Transmitter without Dip Switches
- Test Pattern Button - Transmitter with Dip Switches
- The Receiver
- Indicator Troubleshooting Lights - Receiver
- Settings Button - Receiver
- IR Configuration
- Extracted Audio - L/R OUT
- Audio Extraction Example
- RS-232 Pass-through
- Troubleshooting
- Bandwidth Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
8
Settings Button - Transmitter without Dip
Switches
Use this button to Enable the built in 1080P Color Bar Test pattern.
With the Power unplugged from the Transmitter, hold the SETTINGS button while
plugging the Power back in. To Disable the built in Color Bar Test pattern power
cycle the Transmitter (remove the power for 3 seconds then plug back in).
1920x108P @60Hz
Copy EDID: To COPY EDID from Sink Device move DIP Switches
1, 2, and 3 from OFF (up) to ON (down) at the same time while
connected Sync is powered on. The EDID will be saved until this
process is repeated (move 1, 2, and 3 all back to ON, then all 3
back to OFF).
NOTE: Moving DIP 4 does not aect the COPY EDID function. You can use a coin or other
at object to move all the dip switches together, then once copied move DIP 4 back to
desired position if needed�
DIP Switch 4 is used to set the Down-Scaler
·OFF/UP/0 = Scaler Bypass/OFF
·ON/DOWN/1 = All 4K signals will be down-scaled to 2K