User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- The Transmitter
- Indicator Troubleshooting Lights - Transmitter
- Functions & Setup of the Transmitter
- Settings Button - Transmitter without Dip Switches
- Test Pattern Button - Transmitter with Dip Switches
- The Receiver
- Indicator Troubleshooting Lights - Receiver
- Settings Button - Receiver
- IR Configuration
- Extracted Audio - L/R OUT
- Audio Extraction Example
- RS-232 Pass-through
- Troubleshooting
- Bandwidth Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
13
Extracted Audio - L/R OUT
A feature that is always active on the AC-EX40-444 (TX and Rx) is Audio Extraction. This feature
extracts PCM Audio (2ch) from the source device in order to be run to a separate amplifier or AVR.
BOTH of the audio ports are always active (on TX & Rx).
NOTE - These ports ONLY work if the source is 2Ch�
If down-mixing is needed, check out AC-AVDM-AUHD�
To use the ports:
·Simply plug a 3 pin terminal block into the port on the TX or Rx
(both are always active) and make your own cable assembly.
·There is an option to buy pre-made unbalanced 3-pin to RCA Female cables (AC-CABLE-3PIN-
2CH) see image below.
AC-CABLE-3PIN-2CH