User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- The Transmitter
- Indicator Troubleshooting Lights - Transmitter
- Functions & Setup of the Transmitter
- Settings Button - Transmitter without Dip Switches
- Test Pattern Button - Transmitter with Dip Switches
- The Receiver
- Indicator Troubleshooting Lights - Receiver
- Settings Button - Receiver
- IR Configuration
- Extracted Audio - L/R OUT
- Audio Extraction Example
- RS-232 Pass-through
- Troubleshooting
- Bandwidth Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
10
Settings Button - Receiver
Use this button to Enable/Disable the built in Color Bar Test pattern, there are three
available settings.
Press once to Enable the 2k test pattern, press again to Enable the 4k test pattern,
press a third time to disable.
3840x2160P @30Hz1920x1080P @60Hz
STATUS - On front by HDMI Port: (Blue) This indicator shows that the HDMI sink is
connected. The states are:
·Light Is On (Solid) = Sync w/ HDMI sink is correct and solid.
·Light Is Flashing = The light ashes during the sync process. If it is ashing continuously, a
picture may not be present.
If the BLUE HDMI STATUS LIGHT is ashing, check the following:
1. The source. Plug it directly into the display to be sure it’s functioning properly.
2. Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths, a 2 meter
minimum is recommended per HDMI Specications.
3. If these suggestions do not work, enable the “Test Pattern” (See Page[s] 8). If you see the
pattern, the problem is more than likely between the source and the Transmitter, please try a
dierent source.
4. Contact AVProEdge if these suggestions do not work.