User Manual

Indicator Troubleshooting Lights on the Receiver cont.:
LINK - Above RJ45 (HDBT) Port: (Green) This indicator shows that the AV HDBT link between the
Transmitter and Receiver is in tact. This light will ALWAYS be solid. If this light is flashing or not present do the
following:
1. Check the length. The maximum distances are 70m (230ft) on 4K and 100m (330ft) on 1080P.
2. Remove any coils of cable and make sure that there is not excess cabling.
3. Bypass all patch panels and punch-down blocks.
4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something may be slightly off.
a. Standard RJ45 ends are recommended. Pass through style types can cause interference/crosstalk
5. Contact AVProEdge if these suggestions do not work.
STATUS- Above RJ45 (HDBT) Port: (Amber) This indicator shows that the power is present between the Transmitter and
Receiver. This light ALWAYS BLINKS steadily indicating everything is correct. If you do not see this light, try the following:
1. Check the length. The maximum distances are 70m (230ft) on 4K and 100m (330ft) on 1080P.
2. Remove any coils of cable and make sure that there is not excess cabling.
3. Bypass all patch panels and punch-down blocks.
4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something
may be slightly off.
a. Standard RJ45 ends are recommended. Pass through style types can cause interference/
crosstalk
5. Try powering from the Receiver instead of the Transmitter (See Receiver page for more about
PoE direction).
6. Contact AVProEdge if these suggestions do not work.
AC-EX40-444-PLUS
Page 9
• TX (Default)
= You will need to
power
the TRANSMITTER, the receiver will be powered over
the CAT Cable (Default).
•
RX
= You will need to power the RECEIVER, the transmitter will be powered over the CAT
Cable from the receiver (This is called "Reverse Power").
AUDIO IN SELECT Slide Switch : : (On the front) This is used to select the audio for the TOSLINK port.
There are two options (you are choosing where the audio is extracted from at the Transmitter:
• ARC(TV) - Audio is sent back to the TRANSMITTER via the ARC HDMI port (be sure to
choose ARC port and enable on display)
• TOS - Audio is sent back to the TRANSMITTER via the TOSLINK Port of the display
(be sure to set audio type in TV if you are limited to 2CH)
POWER FROM Slide Switch : (On the front) This is used to select where the power is coming from.