User Manual

1. Check the length. The maximum distances are 100m (330ft) on 4K and 100m (330ft) on 1080P.
2. Remove any coils of cable and make sure that there is not excess cabling.
3. Bypass all patch panels and punch-down blocks.
4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something may be
slightly off.
a.
*Standard RJ45 ends are recommended. Pass through style types can cause interference/crosstalk
5. Contact AVProEdge if these suggestions do not work.
STATUS- Above RJ45 (HDBT) Port: (AMBER) This is an indicator showing that the power is present between the
Transmitter and Receiver. This light ALWAYS BLINKS steadily indicating everything is OK. If you do not see this light,
attempt the following:
1. Check the length. The maximum distances are 100m (330ft) on 4K and 100m (330ft) on 1080P.
2. Remove any coils of cable and make sure that there is not excess cabling.
3. Bypass all patch panels and punch-down blocks.
4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something may be just
slightly off.
a.
*Standard RJ45 ends are recommended. Pass through style types can cause interference/crosstalk
5. Try powering from the Receiver instead of the Transmitter (See Receiver page for more about PoE direction).
6. Contact AVProEdge if these steps do not work.
Indicator Troubleshooting Lights on the Transmitter cont:
LINK - Above RJ45 (HDBT) Port: (GREEN) This indicator shows that the AV HDBT link between the Tx and Rx is
in tact. This light should ALWAYS be solid. If this light is flashing or not present attempt following:
AC-EX40-444-PLUS
Page 6
• TX (Default)
= You will need to
power
the TRANSMITTER, the receiver will be powered over
the CAT Cable (Default).
•
RX
= You will need to power the RECEIVER, the transmitter will be powered over the CAT
Cable from
the receiver (This is called "Reverse Power").
AUDIO IN SELECT Slide Switch : : (On the front) This is used to select the audio for the TOSLINK port.
There are two options (you are choosing where the audio is extracted from at the Transmitter:
• ARC(TV) - Audio is received back from the Receiver and played on the TOSLINK port
(be sure to set audio in TV if you are limited to 2CH)
• TOS - Audio is extracted from the SOURCE ONLY to the TOSLINK port
POWER FROM Slide Switch : (On the front) This is used to select where the power is coming from.