User Manual

 The Transmitter
Front
Indicator Troubleshooting Lights on the Transmitter:
POWER - On the front: (Red) This is an indicator that the power is connected.
There are only two states for light:
• Light Is On = Power supply is connected and functioning
• Light Is Off = Power supply is not connected or there is no power present. (In order to have power: check the
power supply, USP, Outlet, etc...)
AV SYSTEM ACT - On the front: (Blue)
This is an indicator of activity on the link - this light will blink randomly as data is sent/received
HDBaseT LINK - On the front: (Blue)
This is an indicator that that the RJ45 HDBaseT Link is stable. This light should always be SOLID
HDMI SIGNAL MONITOR - On the front: (Blue)
This indicator shows that the HDMI source is connected. This Light should always be SOLID
If the
BLUE HDMI SIGNAL MONITOR LIGHT is OFF, check the following:
1. The source. Plug it directly into the display to be sure it's functioning properly
2. Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths
3. Set the EDID to state #1 (See below)
4. Contact AVProEdge if these suggestions do not work
Back
HDBaseT
HDMI
Loop Out
HDMI In
48V
USB Host
Digital
Audio Out
USB
Device
IR Mode
Micro USB
(Firmware)
Audio Mode
IR In
IR Out
AC-EX40-444-PLUS
Page 5
RS232
(COM & Pass-
through)