Installation Instructions

9
Remove access panels that are held on by magnets. Remove these by using the yellow suction cups on the panel and put them in
safe place until installation is complete.
Place all accessories to the side. Make sure no loose parts are hanging. Lift and carry the bath only by the deck or frame. Protect
the bottom of the bath to avoid breaking the jets at the bottom. Only accessories approved by Mobility Bathworks walk in tub
should be used with this product.
All Mobility Bathworks walk in tubs are tested and operating in our factory prior to shipment. Transportation and/or mishandling
may cause leaks. Testing the walk in tub while you have access to all sides is important !! Only after all of the water and electrical
testing is completed, and all fixtures have been checked, the tub should be installed to the surround wall or walls. Place the Walk in
Tub on a flat surface where the water can be drained. With a clean rag, clean the door seal on your Walk in Tub to remove any de-
bris left from the manufacturing process.
Use Suction Cup to
take Off Panel