Installation Instructions

23
After both the electrical and plumbing installation are done, a final inspection of these parts needs to
be completed before finishing the installation.
Close the drain and fill the walk in tub until it is up to a normal water height level which is 1” to 2” be-
low the overflow and drain lever.
Closed
Open
Overflow and Drain Lever
Allow the water to stand in Walk in Tub for 30 minutes and then inspect all plumbing and seats for
leaks. If there are any leaks or concerns call 512-522-2284 ( BATH )
If the Walk in Tub is jetted, supply electricity to unit and run for 10 minutes then inspect for leaks.