Installation Instructions

14
1. To install the faucet set, begin by using masking tape on the fiberglass surface over the are to be
marked-off and drilled.
2. Mark the position of the holes for the faucets / taps onto the taped off area. Be sure that your
piping will not be obstructed by the walk in tub stainless steel framework or any other obstacle.
Remember : Measure twice and cut once.
3. To cut the holes use a coring bit. Using the tape to help with a clean cut, drill through the
surface.
4. Connect the hot and cold water supply lines with a 3/4” water heated type flex hose adapter with
a female connector.
Caution: Be sure the flex hose has rubber washers on both ends
In a case where the plumbing is not on the same side as it is on your Mobility Bathworks walk in
tub, the plumbing may run underneath the walk in tub.