Installation Instructions

11
1. Dry fit the plumbing before final assembly to make sure that the pipe lengths are correct and there
is proper clearance throughout.
2. Make sure the hole around the drain is leveled under the tub. If not sand down with sandpaper.
3. Assemble kit as shown. Check your local plumbing codes to insure that proper fixatives ( glue )
are used.
4. Tighten down the nuts.
5. Install Overflow elbow with gasket. Secure to the tub with retaining plate and nut, install cover
plate and secure with set screw.
6. Install a pipe section so that the door drain tube is located on the horizontal center line.
7. Install the waste elbow with actuator gasket. Secure to the bath with strainer plate and nut.
Caution :
8. Be sure to adjust the stopper height to allow
proper drain function. Test for proper drain function
before continuing. Once the drain is effectively
draining at the desired height, tighten the screw
on top of the strainer to secure drain cap height.