Operator`s manual

7. Chases - Page 85

TitanMobile_Man_v4-0.doc 07/04/2011 13:46:00

• Press [Fixture Overlap] then enter 0-100 on the keypad to

change how fixtures overlap in the cue. 100% (the normal

setting) means all fixtures fade together. 0% means that the

first fixture will finish its fade before the next one starts giving a

“rolling” change across a range of fixtures. 50% means that the

fixture will start fading when the first one is half way

through its fade. The order of the fixtures is set by the order

you selected them when the cue was saved; you can change

the order using Unfold.

Note: From v3 software, [Cue Overlap] is no longer available in

chases. Instead use a Cue List set to “Link With Previous”

and set the Offset as desired.

7.6.2 Individual cue times in chases

You can configure each cue in a chase to have its own timing

information. You can use the Playback View window, or the Unfold

function to set individual times for cues in chases.

Note: It is easier to use a Cue List rather than a chase if you need a

lot of different timings or link/unlinks. Cue lists are described

in the next chapter.

Using the Playback View

window:

1> Touch the

playback display

for the fader, or

press View then

the swop button of

the playback. The

Playback View

window will open.

2> In the grid, touch

the times you