User Guide

6. Cues - Page 73

PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00

The times are set like this:

1> Press [Edit Times] at the top level menu.

2> Press the Swop button of the cue.

3> Press [Fade Mode x] to set the cue mode. This sets how the

times are used, see below.

4> Press [Delay time] to set the delay before the cue starts, [Fade

time] to set the fade-in time of the cue, and [Fade out time] to

set the fade-out time of the cue.

5> Type the new time (in seconds) using the numeric keypad and

press Enter to save it.

6> Press [Fixture Overlap] to change the overlap, then enter 0-100

on the keypad. 100% means all fixtures fade together. 0%

means that the first fixture will finish its fade before the next

one starts. 50% means that the 2

fixture will start fading

when the first one is half way through its fade. The order of the

fixtures is set by the order you selected them (but you can

change this, see section

6.6.2).

7> Press Exit to get out of Edit Times mode.

• You can also set independent times for the IPCGBES attribute