User Guide

Copyright Avolites Limited 2010
Page 156 – 15. Release notes
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
the fixture patch view has been resolved. On Tiger Touch if you
entered a handle number the page assigned would be 1 more than
the page displayed.
Setting Cue List Delay In To Fractional Ammount: Found in
version: 2.0 - An issue with assigning fractional delay in times to cue
list cues has been resolved. Previously the test input field for 'Delay
In' would not accept the decimal point.
Channel Grid Failed To Load Columns When Switching View:
Found in version: 2.0 - There was an issue with the Channel Grid
where if you went into Programmer mode and cleared the
programmer then went back to Ouput it would not always reload the
columns. This has been fixed.
Playbacks View Showed Extra Letter: Found in version: 2.0 - A
display issue with the Playbacks display has been resolved. When
setting a legend on a playback if you deleted all the letters of the
legend you had typed the playbacks display would continue to show
the first letter until you started to enter a new legend.
Playbacks View Failed With Deleting Cues In Unfold: Found in
version: 2.0 - The Playbacks display had an issue where if a number
of cues were deleted in Unfold it could show blank. This has been
resolved.
Connected Playback Wheel View Would Not Update: Found in
version: 2.0 - The connected playbck wheel view would not update if
you added cues whilst the playback was live. In order to update the
list of cues you had to disconnect the playback and connect again.
Now the view updates dynamically as you add cues.
Groups Showed Incorrect Number: Found in version: 2.0 - If you
recorded groups without a legend then the group handle button
would show the handle index of the group instead of the user
number. The group button now always shows the user number.
Fixture LEDs stay lit after delete: Found in version: 2.0 - When
deleting a lot of fixtures some LEDs stayed lit until you changed page.
This is resolved.
Attribute Options Assigned To Two Wheels: Found in version:
2.0 - On consoles with three attribute wheels the Attribute Options
menu only assingned attributes to two. Now it assigns the correct
number of attributes.
Clear Button Fails To Clear Locate Intenstity: Found in version:
2.0 - Ocasionally Clear could fail to clear fixture intesity. If you
located a fixture so the light came on, edited an indivdual attribute
then cleared that individual attribute the Clear function would no
longer clear the fixture's locate values unless you selected the fixture
again.
Replace Shared Palette: Found in version: 2.0 - If you replaced the
contents of a shared palette with another shared palette with more
than one kind of fixture in the programmer it would only record one
fixture type. This is resolved.
Update Palette: Found in version: 2.0 - If you set a mask in the
record palette menu then subsequently used update pallete the
record palette mask was used to filter the update. This led to updates
in the programmer sometimes not getting merged into the palette.
Update palette now always records all the changes in the update