User Guide

Page 14 – 1. Setting up the console

PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00

The main controls

• The Preset Faders are used to control individual dimmer channels

and fixture intensities. Cues and chases can also be stored on these

faders. The 2 buttons below the faders are used to select and flash

whatever is stored on the fader. Each fader and buttons is called a

“Handle”.

• The Mode select keyswitch selects Programming, Run or System

modes of operation.

• The Page select rollers let you select different pages of playbacks,

and you can write the playback names on the rollers so you know

what’s in them. There are 2 rollers each controlling 10 playback faders

• The Master faders control the overall output of the various parts of

the console. You will normally have these set at Full.

• The Playback faders and flash buttons are used to play back cues or

chases you have programmed, when you are running a show.

• The Main display is the nerve centre of the console and shows you

what is going on. The display can show various screens of information.

• The Control wheels are used to set control values on the fixtures,

and to set chase speeds and fades.

Preset faders / handles

Mode select keyswitch

Main display

Master faders

Attribute

select buttons

Playback faders &

flash buttons

Playback page

select rollers

Control

wheels

softkeys

Command

buttons

Numeric

keypad and

controls

Fixture page

buttons