Operator`s manual

4. Controlling dimmers and fixtures - Page 71
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
• To miss out fixtures in a range, use [Not], for example 1
Through 4 Not 3 Enter will select 1, 2, and 4.
• The @ softkey sets a dimmer level to the selected fixtures, for
example 1 Through 8 @ 5 Enter will set 1-8 at 50%. (You can
choose whether 50% is entered as “5” or “50” in the User
Settings – see section
12.3.3 on page 198). When you press @
there are softkey options for Full, Off and +/- (increase or
decrease brightness).
• You can work with Groups using the Group button, for example
Group 1 And Group 2 Not 5 Enter will select all fixtures in group
1 and group 2 except for fixture 5.
• You can use the Locate button instead of Enter, to select
fixtures and locate them. For example 1 Through 4 Locate will
select fixtures 1 to 4 and locate them.
• When entering a command, the command line is shown on the
display. You can go back using the grey Back button and you
can abandon the line using the grey @ button.
• The AND, THRO and @ functions are also provided on the grey
buttons at the bottom of the numeric keypad as printed next to
the buttons.
4.1.10 Selecting using a pattern
When programming you will often want to select patterns of fixtures.
Rather than having to individually select and deselect fixtures,
the
Pearl Expert has an easy way of selecting odd then even fixtures in a
range of fixtures, or it can, for example, select every 4
th
fixture.
1> Select some fixtures.
2> Press the white All button (below the Next Time button to the
right of the wheels).