Operator`s manual

4. Controlling dimmers and fixtures - Page 63
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
You can also use Unfold to expand the cells onto individual select
buttons. In the Fixtures workspace, the current page of fixtures will
be replaced by select buttons for each individual fixture cell. On the
preset faders, the unfolded fixture cells will start at preset 1.
There are two ways to unfold fixture cells:
• Press Unfold then select range of fixtures. The cells will
immediately appear on the handles.
• Select fixtures, press Unfold, then press [Selected Fixtures].
This method allows for non-consecutive fixtures to be unfolded.
To go back to normal, press Unfold then [Exit Unfold].
You can also use the numeric keypad to quickly select cells. The
syntax is as follows:
.
all sub fixtures of
selection
n.
all sub fixtures of
fixture n
. THRO .j
sub fixtures 1Æj of
all selected
fixtures
n. THRO
all sub fixtures of
fixture nÆlast
consecutive of
type n
THRO .j
shorthand for
above
n. THRO i
sub fixtures 1Æi
of fixture n
.m
sub fixture m of all
selected fixtures
n. THRO i.j
sub fixtures 1Æj
of fixtures nÆi
.m THRO
sub fixtures
mÆlast of all
selected fixtures
n.m
sub fixture m of
fixture n
.m THRO .j
sub fixtures mÆj
of all selected
fixtures
n.m THRO
sub fixtures
mÆlast of fixture
n
.m THRO j
shorthand for
above
n.m THRO i
sub fixtures mÆi
of fixture n
n THRO i.
all sub fixtures of
fixtures nÆi
n.m THRO i.
sub fixture
mÆlast of fixtures
nÆi
n THRO i.j
sub fixture j of
fixtures nÆi
n.m THRO i.j sub fixtures mÆj
of fixtures nÆi
n THRO .j
sub fixture 1Æj of
fixture n
n.m THRO .j sub fixtures mÆj
of fixture n
4.1.5 Changing attributes using the wheels
“Attributes” are the functions of the fixture, like pan, tilt, colour,
dimmer, etc. You select which attributes you want to modify using
the Attribute Bank buttons and set values using the wheels. The
attributes available depend on the fixture type. Dimmer channels only
have a dimmer attribute.