Operator`s manual

Page 62 – 4. Controlling dimmers and fixtures
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
given a list of attributes in the Programmer – press the
appropriate softkey to clear that attribute.
• [Clear All Programmers] will clear all programmers that are
currently active on the console. This will be used for multi-user
programming in future and is currently used to clear values
added to the Titan Remote programmer.
The options in the “Clear Options” submenu are:
• [Auto Reset Mask] sets the mask to be automatically reset to
clear everything each time Clear is pressed, or you can toggle
the option to [Remember Mask] which will keep the mask
setting you used last time.
• [Leave/Zero Preset Fader Levels] is used to set whether latched
fixtures are cleared (the fixture key profile can be set to “Latch”
mode, which turns on the fixture dimmer channel when the
fixture button is touched. See section
12.2.1 on page 196.)
• [Freeze current values] sets what happens to LTP (non-
intensity) channels you have modified. If set to [Freeze Current
Values] the channels remain as you set them. If set to [Release
To Playback Values] the channels will go back to how they are
set in the current playback. For example: you have an active
playback making some lights green, then you select the lights
and change them to red. If you press Clear with this option set
to [Freeze] then the lights remain red. If the option is [Release]
the lights will go back to green.
• [Clear/Maintain Cue Times] - determines whether or not to
clear the cue time information from the programmer (this will
not affect fixture attribute times in the programmer).
You can use the Channel Grid window to selectively attributes from
fixtures. See section
4.2.1 on page 81.
4.1.4 Fixtures with multiple cells/subfixtures
If a fixture has multiple cells of control (for example an RGB LED
batten) and its personality supports it, you can select and control the
fixture either as a whole or as independent cells. This is particularly
useful when using Shapes or the Pixel Mapper.
If you select the fixture using the handle it is patched on, all cells of
the fixture will be controlled together.
You can use the buttons which appear at the top of the attribute
editor window to select the main fixture, or individual cells for control
(use the [Open Workspace Window] softkey to open the Attribute
Editor window).