Operator`s manual

Page 60 – 4. Controlling dimmers and fixtures
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
• Press Clear (right of numeric keys) to deselect all fixtures and
remove all changes from the programmer. See the next section
for more Clear options.
• Once you have changed any attribute, pressing a Select button
will deselect all fixtures and start the selection process again.
All previously selected fixtures (since you last pressed Clear)
stay in the programmer. Once a fixture has been edited, if it’s
on a touch button the button shows a darker blue (also on the
HUD). The picture below shows the first two fixtures selected,
with the second three in the programmer and the others
unselected.
• You can select fixtures on another page by pressing one of the
Pages of Fixtures buttons (above the numeric keys). Palettes,
groups and any cues you have saved on the preset faders will
also change with the fixture page. On the Touch Wing you use
the scroll slider, or the page buttons to the left of the fixture
buttons, if you have 'Pages' set to Show (using the context
button to the left of the menu buttons)
• Using Key Profiles (see section
12.2.1 on page 196) you can set
the fixture touch button to latch mode so that it turns the
fixture’s dimmer channel on (like putting a preset fader to full).
4.1.2 Setting fixtures to a start position (Locate)
The Locate button (the button on the bottom right corner of the
console) is used to put the fixture into a known position with light
coming out, so that you can start programming it.
A quick press of the button will move all selected fixtures to a central
position and reset all the attributes so that you get a white light.
However you sometimes might not want to move the fixture, and by
holding down the Locate button, you get some more options.
• You can mask off some of the Locate settings (such as only
turning the fixture on, but not changing its position or colour)
by holding down Locate and pressing [Set Mask to Exclude All].
Then (still holding Locate) turn on the Attributes you want to
change using the Attribute Bank buttons down the right hand
side. Only the lit attributes will be changed by Locate. Pressing
the Attribute Options button (just above Locate) will clear the
mask.
Scroll slider