Operator`s manual

2. Setting up and using the console - Page 39
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
browser. You can import items from more than one show at
once by repeating steps 1-3.
5> Click on the Mapper tab, and select your imported show.
6> Select a fixture in your imported show, then click the arrow
beside the fixture it maps to in the current show. To remove a
mapping, click the [Clear Fixture Mapping] context button.
7> When you have mapped all fixtures you want to import data
from, click on the Show Library tab.
8> Select the items you want to import (single or multiple). Use
the buttons on the left to select Palettes, Groups etc.
9> Select handle(s) where you want to store the imported items.
10> When you have imported all the items you want, press Exit.
• You can filter fixture types to make the mapping easier using
the buttons on the left and right sides of the show browser.
• You can directly import shows without using the Disk menu by
clicking the Plus button at the top right of the Show Browser.
2.5.4 Autosave
The console will automatically save your show to its internal hard disk
when you shut it down. It will also autosave the show every 30
minutes in case the console loses power.
You can disable Autosave or alter the time between saves using
option [Auto Save] on the Disk menu (selected using the blue Disk
button). You can reload Autosave files using the Show Browser.
We recommend that you have autosave enabled while
programming in case the power fails, but disable it while
running a show as it can cause the console to pause
slightly at inconvenient moments.
2.5.5 Backing up existing show files to USB pen drive
If you just want to save a copy of your current show, you can use the
normal save function to save it to the USB drive instead of the hard
drive.
To copy an existing show file on the hard disk to a USB drive, first
ensure your current show is saved, then use the Disk functions to
load the existing show from hard disk, then save it to the USB drive.
Alternatively you can use the Folders command on the Tools menu.
2.6 Clearing the console
When you start a new show on the Pearl Expert it is usually a good
idea to clear the console. All programming and patching is deleted,
but user options are not changed.
1> Press the Disk button.
2> Press [New Show].
3> Press [OK] to confirm.
4> Press Exit to leave Disk mode.
• When starting a new show you have the option to keep existing
DMX settings. This preserves the DMX/TitanNet configuration of