Operator`s manual

Page 32 – 2. Setting up and using the console
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
operation of the console for a particular use. See section 12.2 on
page
196 for details.
2.3.7 Undo/Redo
You can undo and redo up to 20 actions by pressing Avo shift and the
Undo or Redo buttons below the numeric keypad (on black Pearl
Expert consoles these are the Left arrow (Undo) and Right arrow
(Redo) buttons). So for example if you press Clear then wish you
hadn’t, the Undo function will restore the console state.
You can use undo/redo on the following actions:
• Fixture selection
• Attribute adjustment (eg Pan, Tilt, colour changes)
• Locate
• Clear
• Keypad input
• Applying Palettes
• Group selection
• Off
• Align
• Flip
2.3.8 Key macro buttons
Lighting programming can sometimes require a repeated sequence of
button presses. You can record sequences of keypresses and play
them back with a single keypress – this is called a macro.
Macros can be stored in any of the grey palette buttons on the
presets, and there is also a Macro button window which can be shown
on the Touch Wing or the screen.
To record a macro:
1> Press the Macro button (above keypad)
2> Press [Record]
3> Press an empty grey Palette button, or an empty button in the
Macro window on the screen. Recording starts. The
Insert/Macro button flashes during recording.
4> Press the sequence of buttons you want to record.
5> Press Record Macro to finish recording.
To play back the macro, just press or touch the button where you
recorded the macro. The macro will repeat all your button presses
(but there is no delay or timing between the presses).
2.3.9 Keyboard shortcuts
Many features of the console can be controlled by shortcuts on the
keyboard. These are especially useful when using Titan Mobile or
Titan Simulator.
The Titan application “captures” the keyboard on start up, meaning
that if you try to use other applications at the same time they will not