Operator`s manual

Page 24 – 2. Setting up and using the console
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
A 3-pin XLR socket for a desk lamp is provided on the rear edge of
the console. Suitable lamps are available from Avolites. The lamps
are 12 volt, wired from pins 1 (negative) and 2 (positive) of the XLR.
2.2.8 Connecting the Touch Wing
The Touch Wing connects to the DVI port and the 9-pin D connector
on the rear of the console, just above the panel with the rear
USB/network sockets.
2.3 Using the menus, monitor and Touch Wing
As well as the onboard LCD screen, the Pearl Expert provides further
controls and information on its external monitor and on the Touch
Wing.
2.3.1 The onboard LCD screen
Down the right hand side of the display, the functions of the A-G
menu softkeys are listed. In this manual these are shown in square
brackets [Like This]. If there are more functions than will fit on one
screen, [Previous] and [Next] buttons are provided to page through
the functions.
The vertical bar to the left of the softkeys shows you which menu you
are currently in. You can 'latch' the menu (so that you don’t have to
keep reselecting it) by pressing the ML Menu button.
At the bottom left of the screen, the current function of the wheels is
shown. If fixture attributes are being set, this shows the possible
Menu
softkeys
Current
menu name
Information
window
Wheel A/B
attributes
List of
settings
Current
selection
Fixture
intensities