Operator`s manual

16. Release notes - Page 239
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
Pressing ML while in Edit Palette exits and clears programmer:
On Sapphire Touch and Titan Mobile consoles attempting to enter the
ML Menu from the Edit Palette menu would cause it to exit the Edit
Palette function and clear the programmer. This has been resolved.
Patch active over manual gives error: Previously, attempting to
link an active fixture by patching over the top of a manually patched
fixture would result in an error prompt. It is now possible to link
active fixtures by patching over manual.
Link chains: Previously if you created a number of playbacks that
were linked to one another changes to the first playback would
propogate to the second playback only. Now changes to a linked cue
at any point in the chain will propogate across the whole chain.
Groups grey out when setting fixture order: Previously groups in
the groups workspace would grey-out when setting fixture orders.
This was misleading as groups can be used as part of setting fixture
orders. They now stay lit.
Slow performance on large cuelists: Appending cues to cuelists
would get progressively slower each time a new cue was added. In
large cuelists this could become quite significant. Various
improvements have been made to cuelist tracking updates to ensure
this is no longer a problem.
Changing active cue to mode 1 results in delay then snap:
Fixed an issue where changing an active mode 0 intensity cue to a
mode 1 with fade out would result in a delay then snap out. It will
now fade out over the set time as soon as the cue is killed.
Patch selection does not remain after closing patch view:
Previously if you selected a fixture to patch in patch view and then
closed patch view it would forget the selection. This was a problem if
you needed to close the patch view to see the fixture workspace.
Patch selection is now remembered after closing patch view.
Playbacks from legacy shows don't get user numbers: When
loading shows from version 5 or earlier playbacks would not be
assigned user numbers. This meant it was not possible to use the
command line syntax to copy or move cues. Legacy show playbacks
now have user numbers.
ST help menu missing: Fixed an issue where the help menu did not
open the relevant options on the Sapphire Touch.
Mode 3 crossfade between identical values: Previously if you
fired a timed mode 3 playback that contained some identical values
as another active playback (for example 100% dimmer) the values
would change when they should not. This has been resolved.
Pattern selection in edit times: Previously the times grid would
highlight cells according to pattern selection but values input would
ignore this and apply to all fixtures. This has been fixed and it is now
possible to use pattern selections when editing times.
Channel grid does not update after sub-fixture exchange:
Previously if you exchanged a multi-cell fixture ghosts of the old
fixture would remain if channel grid was open and the new fixture
would not populate after closing/reopening. This has been fixed.
Master playback options: Attempting to set Playback Options
would result in the previously selected handle being selected instead
of the master handle. This made it seem like changes to masters