Operator`s manual

16. Release notes - Page 237
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
Renumber changes: 'Renumber cues' has been renamed 'Renumber
ALL cues' and a prompt with [Confirm] or [Cancel] has been added to
prevent accidental operation. A Renumber All Cues button has also
been added to the Playback Options menu so that it is easier to find.
Renumber cue from Set Legend: It is now possible to renumber
individual cues from the Set Legend menu.
Remove show loaded prompt: The show saved/loaded [OK]
prompt has been removed. Following a successful save or load you
will now immediately be returned to the root menu.
TM executor buttons key profiles: The Titan Mobile executor
buttons are now treated as touch keys in key profiles.
Reordered cue list cue times menu softkeys: The Edit Cue List
Cue Times menu softkeys have been reordered to keep similar
settings within pages.
Prevent fixture cell deletion: Previously it was possible to delete
individual cells after unfolding a fixture. Attempts to do this will now
be blocked and a warning is shown instead.
Removed preload from cue list view: Preload has been removed
from cue list view as it has been made obsolete with the introduction
of MID.
Advanced include start new selection: When using advanced
include selecting a fixture will now deselect all fixtures and begin a
new selection to unify standard selection rules across the platform.
Attribute editor naming consistency: The factory workspace
shortcut to open the Attribute Editor workspace has now been
renamed to 'Attribute Editor' for parity.
Previous fixture highlights end of selection: Pressing the
previous fixture button will now highlight the end of the selection.
Renamed key profile +/-5% to Nudge Up and Nudge Down:
The +/-5% key profile options have been renamed to 'Nudge Up' and
'Nudge Down' to avoid confusion.
Default timecode framerate 25: The default timecode framerate
has been changed to 25 to avoid frame offsets increasing into invalid
values.
16.1.5 Bugs fixed
Replace Palette Legend: Previously if you tried to set a legend
when replacing a palette the old legend would persist. This has been
fixed.
Renumber conflicts result in user number zero: Fixed an issue
where renumbering over a range of items could result in all fixtures
being set to user number zero if any were already in use.
Include runs individual channel fades: Previously if you included
a playback with individual fade times it would run the fades. Include
now ignores any fade times and snaps in.
Repatch fixtures spanning universes: Fixed an issue where it was
not possible repatch a range of fixtures that spanned more than one
universe.