Operator`s manual

12. User Settings and other options - Page 207
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
To use the recovery CD, turn off the console, place the CD in the
drive and turn on the power. To use a USB stick, you will need to
change the BIOS to boot from USB - hold down Delete while powering
on the console to enter BIOS, then enter the password 68340. Go to
the boot menu and put the USB drive at the top of the list. After you
have installed the software, go back into the BIOS and change boot
back to the internal hard disk.
Using the recovery CD will delete all settings and files
from the console including show files and user
personalities. Any files should be saved to a USB stick
before continuing.
After starting the console will install all the software and drivers
required to run. This takes approximately 30 minutes to complete
during which the console will reboot a number of times. Please do not
switch off the console during this process.
12.7.1 After Installation
Once complete the console will boot into the operating system and
you will be required to enter the activation code to unlock Titan. A
dialog box should be shown on screen asking for the activation code
which can be typed in using the numeric keypad. If the dialog box is
not visible it may be hidden by another window, in which case use the
switch task menu and select 'Pearl Expert Titan'. The activation code
can be found in the keyboard drawer. Once the activation code has
been entered successfully, please restart the console.