Operator`s manual

Page 184 – 10. Running the show
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
To turn off a playback, send a note on command with velocity=0. The
console does not recognise MIDI note off ($8n) commands.
Stop/run/step a chase etc: after touch ($An pp cc)
Note number (pp) = playback number, from 0 - 19 (decimal)
Aftertouch value (cc) = control codes:
$00 stop chase
$01 run chase
$02 restart from step 1
$03 fade to next step using programmed fade times
$04 snap directly to next step
10.6 Running a second console as backup
On many shows it is important to have a backup console running in
case the main console fails during the show. Titan allows you to run a
second console over the network which it keeps synchronised with
the main console. Should the worst happen, a single keypress can
transfer control to the backup console.
10.6.1 Setting up consoles for backup
Any Titan console can act as backup for any other console, they do
not have to be the same model. For example you could run Titan
Mobile as backup.
However do think about what parts of your show you will not be able
to access if the backup device has less faders/handles than the main
console.
1> Connect both consoles to the same network and ensure they
are set to the same IP range (see section 14 on page 213).
2> Press Disk, [TitanNet Sessions (Backup)].
3> Consoles available for backup will be listed in the softkeys.
4> Selecting a console will place that console into backup mode
and sync the show to it.
5> The backup console will show a display indicating the backup
status and show name.
In backup mode the backup console screen displays the current
connection and sync status including current show name.