Operator`s manual

8. Chases - Page 153
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
It is easier to use a Cue List rather than a chase if you
need a lot of different timings or link/unlinks. Cue lists
are described in the next chapter.
Using the Playback View window:
1> Touch the playback display relating to the fader, or press
View
then the swop button of the playback. The Playback View
window will open.
2> In the grid, touch the times you want to edit.
3> Use the softkey options to change the times or settings.
4> Repeat from 2 to change other times or settings.
• You can change a range of cues all at once by dragging across
the grid to select multiple cells, or you can use wheel B to select
multiple cells for editing.
Using Unfold:
1> Press the Unfold button, then the Swop button of the chase to
be edited.
2> Press [Edit Times] then the Swop button of the unfolded cue
you want to edit.
3> Set up the timing options as required. The options are
described below.
4> Press Unfold to get out of unfold mode.
Initially all the timing options are set to Global. You can cancel any
individual timings and set the time back to global timings by pressing
the softkey for the option then pressing [Use Global].
The timing options for the cue are:
• Delay
• Fade (in)
• Fade Out
• Fixture Overlap
• Link with previous step
• Attribute times (see next section)