Operator`s manual

6. Shapes and Pixel Mapper effects - Page 109
TitanUniversal_Man_v7-0_PE.doc 02 September 2013
Reduce 'Spawn Rate' until only one stripe is on screen the same
time. For this type of effect the value will usually need to be
quite low - approximately 0.2.
You might want to reduce 'Speed' slightly at this point. (Note
that a higher speed was initially useful for getting the correct
spawn rate above.)
5> Click on [Layer 2], select [+] and select the Swirl element
(represented by a 'fan' shape with four arms).
Increase 'Zoom' until it is as large as will fit in the screen.
Set 'Bend' to 0% for nice straight fan blade edges.
Set 'Points' to 3 (minimum) for a three bladed fan.
Set 'Thickness' to 50% for evenly sized segments.
Increase 'Border Width' to a low value so that we just have an
outline.
6> Click on [+] and add a spin animation.
Reduce the speed until it just causes a light breeze.
7> Click in the top of this layer to get the layer controls.
Click on the colour bar to open the colour picker.
Click and drag to the top left of the picker window to get a
strong red.