Operator`s manual

Copyright Avolites Limited 2010
6. Cues - Page 81
PearlExpertTitan_Man_v4.doc 29/09/2010 16:27:00
cue was created, but you might want to change this (for example to
pair up fixtures so they move together).
1> Press [Edit Times] at
the top level menu.
2> Press the Swop button
of the cue to be
changed.
3> Press [Fixture Order].
4> Set the sequence number to start from using option A.
5> If you want the sequence number to increase automatically, set
[Autoincrement] to On. If you want some fixtures to have the
same sequence number, set it to Off.
6> Press or touch the Select buttons of the fixture(s) you want to
place in that position in the sequence. The sequence number is
shown on the HUD or in the top right hand corner of the fixture
select touch buttons.
7> Press Exit to finish.
• You can set several fixtures to have the same sequence
number. This means, for example, when used with Overlap they
will all do the same thing at the same time.
• You can remove a fixture from the sequence by giving it the
same sequence number it already has. The fixture sequence will
show X. Touch
the button again
to put it back in
the sequence.
On the Touch Wing
the fixture sequence
is shown on the touch
button as shown in
the picture on the
right.
6.6.3 Setting attribute fade times for a cue
You can set individual fade times for each attribute group (such as
Position). If you set a time, it overrides the normal times.
To set an attribute group fade time:
1> Press [Edit Times] at the top level menu.
2> Press the Swop button of the cue to be changed.
3> Press the Attribute Bank button (right hand side) for the
attribute you want to change.
4> Press [Delay] to set delay time or [Set fade] to set fade time.
5> Type the new time using the numeric keypad and press Enter to
save it, or press [Use Global] to delete the attribute times and
go back to the normal times.
6> Press Enter to save the changes.