Operator`s manual

6. Cues - Page 79

PearlExpertTitan_Man_v4.doc 29/09/2010 16:27:00

6.6.1 Setting fade times and Overlap for a cue

You can set a delay, fade in and fade out time independently for

every cue. Shapes in the cue will also be affected, depending on the

fade mode.

You can delay the fade times between fixtures in a cue so that the

cue is applied sequentially to each fixture. This is called Fixture

Overlap and can create some amazing “peel off” or “roll” type effects

with no programming at all.

In the diagram below, the top picture shows how the LTP channels

change when used with delay, fade and fade out times. The second

picture shows how the HTP channels change. The third and fourth

pictures show what happens to the LTP channels when fixture overlap

and attribute fade are used.

The times are set like this:

1> Press [Edit Times] at the top level menu.

2> Press the Swop button of the cue.

3> Press [Fade Mode x] to set the cue mode. This sets how the

times are used, see below.