User Guide

2. Patching - Page 123
Pearl 2004 Manual v1 - 27th August 2004
E: Find fixture - This option lets you find “lost” fixtures (if you have
set the DMX address and forgotten what it was, or a fixture has
changed its address on its own). You need the VDU screen connected to
use this option as the settings are not shown on the on-board display.
1> Using the cursor arrows, select the type of fixture & press enter
2> Spin wheel A until the fixture responds with its “Locate Fixture”
state (open white beam, central position). Use the cursor up and
down arrows to change one channel at a time.
3> You can change the DMX output line using the A B C D softkeys or
directly enter a channel by pressing softkey G
4> Read the DMX address from the VDU screen.
5> Press Exit when you have finished.
F: Set Default DMX lines - This option sets the DMX line mappings
back to the factory defaults, as shown in Chapter 1. The LCD display
also shows how the DMX lines will be set. Press Softkey A to confirm
the setting.