User Guide

2. How to set up an eDMX system from out of the box. - Page 9
eDMX Operators Manual.doc 10/05/2004 13:37:00
Finally when a successful connection is made then the user should be able
to bring up the WENDI prompt as shown below by depressing the return
key on the attached computer’s keyboard.
Now that the Tube is in contact with the hyper terminal interface, it may
be configured as to the user’s specification.
The Tube has a simple RS232 interface which allows it to accept and
display configuration data from command prompt style instructions. The
interface has been developed to allow communication in a manner similar
to the configuration scripts of most network switches.
To start with it is suggested that on the PC connected to the Tube, that the
user types:
sh conf
The sh represents an abbreviated show command.
The conf represents an abbreviated configuration command.
The user should be presented with the following detail.