User Guide

3. Working with the WAP - Page 15
eDMX Operators Manual.doc 10/05/2004 13:37:00
more information can be found through the help files. To find help on any
other parameter simply type show X, where X is the name of the
parameter, for example show IP details the following:
3. Working with the WAP
The WAP comes with its own configuration setup software which should be
run according to the accompanying manual.
However, after connecting to the WAP either wirelessly or via a cable
through a switch or cat5 cross cable it should be able to reach the web
interface. For the Linksys WAP11 the interface should look like.
Here it can be seen that this WAP has its SSID set to A and its Channel is
set to 1. If the SSID of the Tubes are also set to A then the system will
work and the encoder Tube will route its airborne DMX data via the WAP, if
there is any discrepancy it will not work, please note the SSID is cAsE
SeNsItIvE.
The Channel is the physical frequency which the WAP operates on, there
are different numbers of channels available in different countries around
the world and it is the users responsibility to check that they are using a