User Guide

2. How to set up an eDMX system from out of the box. - Page 13
eDMX Operators Manual.doc 10/05/2004 13:37:00
So to set the IP address for the Tube to 192.168.0.35 you would type
“set ip=192.168.0.35”
It is now imperative that you save the configuration of the Tube at
this stage, otherwise when you reboot the Tube the IP address
change will be forgotten.
To do this type “save conf”
When the configuration has been saved the prompt will tell you that the
operation is successful.
1.6 Changing a TUBE from an Encoder to a Decoder and back again
To set the Tube to decoder mode you simply type “set DMXMode=decoder”
Then type “save conf”
To set the Tube to encoder mode you simply type “set DMXMode=encoder” as
shown below: