User guide

10
H-Position
2
720p (50/60)
V-Position
2
1080i (50/60)
Exit 1080p (50/60)
Native
Note 1: The PC sub-menu is only visible when you have selected PC as your
source.
Note 2: H-Position and V-Position are only available when PC mode is selected.
The Video and PC menus appear when Video or PC modes are selected as an
input. Depending on the mode, additional functionality will be exposed when the
following functions are selected: Picture Mode: User, Standard and Movie.,
Scale: Overscan, Underscan Letterbox and Full Screen., Noise Reduction:
Low, Middle, High and Off.
The Color sub-menu calls up four presets that cause the picture to take on a
specific characteristic. Some people prefer the picture to have a slightly reddish
(“Warm”) appearance. This looks more lifelike to them. Others want a bluish
(“Cool”) hue and still others want to adjust the picture and save it as a “User”
appearance. Finally, there is “Normal” which is an appearance that was created
using special image analysis equipment and is therefore considered a standard
appearance.
The Output sub-menu allows you to specify the resolution you want the
VSS1000PD to produce. As an example, if you are using a DVI display device
that can only accept a 1080i HDTV input signal, you would want to set the output
resolution to 1080i. Keep in mind that setting the resolution can cause an
apparent malfunction if you select a resolution that your display device cannot
reproduce. Make certain your display device can reproduce the resolution you
desire BEFORE you select it.
The OSD sub-menu allows you to customize the way the On Screen Display
appears when it has been accessed. This is a personal preference matter. You
can change the default if you wish or simply leave it at the factory setting.
Lastly, the Info sub-menu contains technical information. If you have problems
with the VSS1000PD and require assistance, the technician may ask you to read
information from this menu to him as part of the troubleshooting process.
6.0 TROUBLESHOOTING
If the VSS1000PD Scaler does not appear to be functioning, make certain that
the source and all other devices connected to the unit are functioning correctly by
connecting each device currently connected to the VSS1000PD’s outputs directly
to the source using a short length of cable. (In other words, bypass the
VSS1000PD to make certain that the problem is not with the source or
destination devices.) If the signal is present under those conditions, make certain