User guide

40 SwitchView OSD Installer/User Guide
Pairing Connections
1. Locate the pairing cable kit. (CDUAL) It will contain a Y-video cable
with two 15-pin male VGA connectors and one 15-pin female VGA
connector. It also contains a 9 pin male serial cable.
2. Plug a male VGA connector into the port labeled on each of the
SwitchView OSD units.
3. Connect the female VGA cable to the end of your monitor cable.
4. Next, connect the serial cable between the ports labeled “SETUP” on the
SwitchView OSD units.
5. Connect a PS/2 mouse to the master SwitchView OSD unit.