User guide

Chapter 4: On-Screen Display Operations 21
The Command Menu
Once you have activated the main OSD Window, you can open the Com-
mand Menu by either pressing the Control key twice or by typing ALT-M.
The Command Menu options are selected in the same manner as channels
in the OSD Window. Scroll the Highlight Bar up and down and press Enter
when your selection is highlighted.
If you are operating in non-secure mode or are the system administrator,
you will have several options that do not appear in the User level Com-
mand Menu: Channel Maintenance, Administrator Functions and Sequen-
tial Scan Dwell Time. Channel Maintenance and Administrator Functions
are both covered in separate sections in this chapter. Scanning is covered
in Chapter 5.
If you experience a loss of mouse signal while using the SwitchView OSD,
select the ‘Reset Standard Mouse/Keyboard’ option from this menu for a
PC with a standard mouse driver or ‘Reset Wheel Mouse/Keyboard’ if you
are using a PC with a Microsoft IntelliMouse driver. This will reset and
in most cases restore your mouse signal. These commands are equivalent
to the <CM> MR <Enter> and <CM> MW <Enter> keyboard command listed in
the ‘System Control & Maintenance’ section of this manual.
Choose the option ‘Version Information’ to display on your monitor the
current version level of your OSD firmware. Press the Esc key to clear this
information from your screen.
Games
Administrator Command Menu
Program Manager
Channel Maintenance
ENTER-accept ESC-previous
Turn Scanning ON
Sequential Scan Dwell Time
Scanning Order
Reset Wheel Mouse/Keyboard
Version Information
Administrator Functions
Reset Standard Mouse/Keyboard
CYBEX Control Panel